Curtain
The curtain shall be constructed using clear polycarbonate infill fitted into extruded aluminium mid-rail of 35mm face-height. Each mid-rail shall be fitted with specially moulded end clips to prevent lateral movement and provide smooth operation within its guide channels.
NOTE: Reverse roll installations are possible and will not affect the appearance of the Roller Shutter curtain. Tapered bottom rails can be manufactured to suit the opening. (Limitations may apply).

Finish
All aluminium sections can be natural anodised as standard. Various anodising and powdercoat colours are also available when specified.

Ventilation (Optional)
The polycarbonate interlocking infill can be pierced with slots 90mm long and 28mm high at 100mm intervals as standard. The pitch distance can be changed to suit requirements (limitations may apply).

Bottom Rail
The bottom rail shall be specially extruded section 2mm thick measuring 85mm in height. It shall have access incorporated into the body of the rail to house a concealed locking system. Provision is available for bottom seals as an option.

Fixing
Plasterboard fixing is not adequate to secure the door components when installed.

Locking
Locking shall entail a centrally mounted, concealed key operated “lock focus” security type lock mechanism. It shall be keyed on the outside or inside (or both sides) fitted onto the bottom rail of the Roller Shutter. In special cases the lock can be fitted into the midlocking rail to facilitate with waist height lock system.

Master Key Locking System (Optional) is available using either:
Lockwood 570; NOTE: The barrel protrudes out by approximately 25mm therefore considerations should be taken to avoid damage.
Lock Focus V9C4; with spin cylinder and sleek appearance with lock protruding only 14mm.

Shootbolt System: Shootbolt system mechanism is also available as an option, which is not concealed as standard locks.

Centre Mullions (Optional)
Centre door mullions can be used for wide openings and/in multiple door installations. Standard centre mullions shall be extruded aluminium of 125mm width and 30mm depth.
The mullions shall always be incorporated with a mullion head which is positioned above the mullion. The mullion shall be a lift-out type, fitted with shootbolts locking at the bottom of the mullion. In case of fixed mullions, the mullion and the head are a single unit and not removable.

Corner Mullions (Optional)
Corner mullions can be used when two shutters meet at a corner. The mullion shall be manufactured from aluminium sheets formed to suit the angle and size as required. The width of the angular corner mullions can be minimised if the drums are vertically staged when installed.
Reverse mullions may be available, depending on application.

Operation
Clearlite Roller Shutters are designed for hand operation as standard however chain or motorisation are available as options, depending on application (limitations may apply).
See Method of Operation.

Motorisation
See Industrial Operators.

PDF DOWNLOADS

Clearlite Aluminium Roller Shutter (.pdf format, get Adobe Acrobat Reader)

Mullion_Aluminium & Timber Roller Shutters (.pdf format, get Adobe Acrobat Reader)

Bulkhead_Aluminium & Timber Roller Shutters (.pdf format, get Adobe Acrobat Reader)

Top