Roller Doors

Canopy


Airport Doors Roller Door canopies are highly recommended for fence-line or freestanding Roller Doors to provide weather protection for the Roller Door operator and the Roller Door itself.

Features
 Weather protection
 Curved canopy
 Allows access to Roller Door (should replacement be required)

Canopy Dimensions

Height: approximately 440mm
Maximum Width: 5380mm (for roller door opening of 5000mm)
Depth: 660mm


Fence-line Roller Doors with Canopies

Canopy Design
The canopy is manufactured from galvanised tube and finished with pre-painted (e.g. Colorbond®) steel flat sheet. See Colour Chart (Roller Doors) for colour availability.

Posts
Galvanised steel posts of 100mm x 100mm x 3mm are concreted 600mm-800mm (depending on soil conditions) into the ground. Cleats (of 50mm x 5mm thick) are fitted to the bottom of posts to provide extra support in the concrete. NOTE: Concrete is of 25MPA strength.

Installation
Standard installation consists of a freestanding canopy on steel posts. The canopy is installed over the Roller Door drum and is fixed to the steel support angles which are welded to the steel posts. NOTE: Canopy installation may vary depending on application. An extra 50mm or 100mm wide piece shall be welded to posts where required for bracket support.

Requirements for Canopy Installation (with Airport Doors Roller Door)
- Sufficient sideroom (minimum 200mm & 250mm motor side). Consult your Airport Doors representative for further information.
- Steel posts
- Minimum Headroom: 700mm (from roller door opening height)

Motorisation
Power must be available to freestanding roller doors. See Roller Door Operators.

Top